Bush Projection Alarm Clock - Black

In standby mode, press and hold SET until the display flashes. 

Whilst the display is flashing, repeatedly press HR and MIN respectively until the desired clock time appears. 

Press and hold HR and MIN together for fast advance. 

Press SET to confirm. 

The hour and minute digits will stop flashing. 

Press Power to switch the unit on. 

The alarm clock will enter radio mode. 

The radio frequency will briefly appear on the display and then return to clock time. 

In standby mode, press and hold AL1/AL2 for 2 seconds. 

The hour and minute digits will flash. 

Whilst the hour and minute digits are flashing, set the alarm time by repeatedly pressing HR and MIN for fast advance. 

Repeatedly press AL1/AL2 to set the alarm to wake to buzzer or radio. 

The corresponding indicator light(s) will illuminate on the display. 

Repeatedly press AL1/AL2 until the alarm indicator light goes out on the display. 

1. Press SLEEP. 
2. ‘90’ will illuminate on the display. 
3. Repeatedly press SLEEP to select the desired sleep time from 90, 80, 70, 60, 50, 40,3, 20, or 10 minutes. 
4. The radio will be turned off after the selected time has elapsed.

Press SLEEP until ‘OFF’ is selected. 

• To turn on or off the projection, press PROJECTOR ON/OFF. 
• To focus the projected time, rotate the projector wheel. 
• To change the projection to a desired angle, rotate the projector.

If you are missing radio stations, we would recommend performing an automatic channel scan on your radio and trying the following:

• Move the radio to an open location, close to a window if possible.
• Locate it further away from other devices to avoid any interference.
• Extend the antenna fully and, if necessary, adjust to receive the strongest signal.

If you are still missing stations, it may be down to your signal coverage. You can check the digital signal coverage in your area using this website here.

We would recommend checking the following if your radio has no sound:

• Ensure the volume is turned up fully.
• Check if this is occurring on all stations, as it may be down to poor signal from a particular station.

If the issue is still occurring, try a power reset:

1. Disconnect the radio from mains/battery power.
2. Holding down Power/Standby button for 30 seconds.
3. Reconnecting the radio up and trying again.

If this has not resolved the issue, please use the contact details on this page to get further support.

To make the most out of your radio and get better signal we recommend the following:

• Move the radio to an open location, close to a window if possible.
• Locate it a bit further away from other devices to avoid any interference.
• Extend the antenna fully and, if necessary, adjust to receive the strongest signal.

For more information about the digital radio signal in your area, we would advise checking the signal information on this website here.

To check the stations available in your area, please use this online postcode checker provided by getdigitalradio.com here.

If the radio has no power, try the following:

• Quick press the Standby button to ensure it is not in Standby mode.
• Try an alternative mains plug socket.
• Change the fuse in the plug.

If the issue remains, please get in touch with the support team by using the contact details on this page.